Cast aluminum heater for water heater, professional name: 3D Max integrated speed heating system is the core of instant heating electric water heater heating system. By the independent water channel three-dimensional surround on the periphery of the heating element, integrated surrounded by waterways, core planar heating and constant temperature control spread heat device, anti dry burning protection device, waterproof scale system design in one, effectively solve the immediate heating system of leakage, leakage, the filthy water, dry and water temperature fits and starts burning etc. safety performance problems, better improve the efficiency and speed. Because of its processing technology for aluminum alloy cast aluminum heating forming technology, commonly known as "cast". Is by independent flow passage of the three-dimensional surround in around the heating element, set around waterways, core planar heating and constant temperature control scattered heating device, anti dry heating protection device, waterproof scale design system is equal to one, effectively solve the immediate heating system of leakage, leakage, scale, dry and water temperature fits and starts burning etc. safety performance problems, better improve the efficiency and speed. Zhongshan City Han Gong Electrical Appliance Co., Ltd. technical staff through years of combined with the efforts of all kinds of water heater and thermal heating technology advantages in R & D of integrated heating system is that the hot type electric water heater heating technology to enhance and improve. And gradually get wide attention and application, and obtain the national utility model patent certificate.

1, the map dimensions in size "B" must be completely immersed in oil, burn out components. Should be heated oil should be no corrosive.

2, SRY3 type of work surface must be in the fastener, the size of the line "B" on the.

3, melting asphalt, paraffin and other solid state oil should be used to reduce the voltage, etc., and then rose to the rated voltage. To prevent the power to reduce the concentration of components to use life.

4, found the tube surface with carbon, to eliminate after use, so as not to reduce efficiency, and even burn the element.

5, components should be stored in a dry, if because of long-term placement and insulation resistance is reduced to less than 1 megohm, drying in the oven for about 200 DEG C for several hours (or low voltage components through hours of), or return of insulation resistance.

Characteristic:

1, most of the hot air in the box, heat efficiency, save energy.

2, the use of forced ventilation, the box can be adjusted by the wind plate, the material is dry and uniform. Heat source can be steam, hot water, electricity, far infrared, wide selection.

3, the whole machine noise, smooth operation. Temperature control, easy installation and maintenance.

4, wide range of application, can be dry all kinds of materials, is a general drying equipment.